Free written estimates in Chicago and the near suburbs

Chicago Tuckpointing Co.Tuckpointing · Chimneys · Brick

A Chicago bungalow masonry guide: what fails first and what to fix

This Chicago bungalow masonry guide is for owners of the brick bungalows built across the city and inner suburbs between about 1910 and 1940. On these houses the chimney, the front steps, the side walls of softer common brick and the steel lintels over the side windows almost always need work before the face brick front does. Knowing that order helps you budget and spot a contractor who wants to redo everything.

Building types4 min readUpdated November 20, 2026

Key takeaways
  • Bungalows have hard face brick in front and soft common brick on the sides and back.
  • Usual failure order: chimney, front steps, weather-side wall, lintels, gangway wall, front.
  • Fix water sources (gutters, downspouts, chimney crown) along with the masonry.
  • Most bungalows need phased, targeted work, not a full-house repoint.

How a Chicago bungalow is built

The classic Chicago bungalow is a one-and-a-half-story brick house on a narrow city lot, usually with the short end facing the street. Many have a bay or an angled front, a low-pitched roof, art-glass windows and a full basement. The Historic Chicago Bungalow Association has documented tens of thousands of them across the city's "bungalow belt", with more in Berwyn, Cicero, Park Ridge and other inner suburbs.

The masonry is typically solid brick, two or three wythes thick, not veneer over wood framing. The front uses harder face brick, often in decorative patterns with limestone trim. The side walls use softer Chicago common brick. Window openings have steel angle lintels, and there's at least one brick chimney.

Quiet residential street lined with houses and trees
On a typical bungalow block the houses are only a few feet apart, which shapes how they weather and how they're repaired.

What fails first, in rough order

OrderPartWhyRepair
1ChimneyExposed on all sides; often vents a boiler or water heaterCrown, repoint or rebuild
2Front steps and wingwallsSalt, snow, shallow footingsReset caps or rebuild
3Weather-side wallSoft common brick facing west or northSpot or full repoint
4Side window lintelsSteel rusting after ~100 yearsLintel replacement
5Gangway wallShaded, slow to dryRepoint, often from narrow scaffold
6Face brick frontHarder brick, better mortarOften spot work only

The gangway problem

Most bungalows sit three to five feet from the house next door. The gangway wall gets little sun and dries slowly, and water off both roofs often lands in that narrow space. It's also awkward to work in: ladders don't angle well, standard scaffold may not fit, and grinding dust lands on the neighbor's house. We use narrow scaffold frames or pump jacks, cover both houses, and let neighbors know before we start.

Local specifics

On many Chicago bungalows the chimney sits on a side wall rather than in the middle of the house, so it rises right beside the gangway. It's also often still venting a gas boiler or water heater through an old clay flue. Condensation from modern appliances attacks the mortar from inside, so these chimneys can look worse than the walls around them. Ask a heating contractor whether the flue needs a liner whenever the chimney is rebuilt.

Budgeting and phasing

A bungalow rarely needs everything at once. A sensible plan for a house that hasn't had major work in decades:

  1. Year 1: chimney (crown or rebuild), worst lintels, anything loose or leaking.
  2. Year 2: full repoint of the weather-side wall; spot work on the gangway side.
  3. Later: front steps if they're stable; front face brick as needed.

Our cost guide works through a Portage Park bungalow example line by line, with a total range of roughly $12,750 to $24,350 for a typical mix of work.

Common bungalow mistakes

  • Hard mortar on common brick: leads to spalling within a few winters. See our mortar guide.
  • Painting or sealing the side walls: traps moisture in soft brick.
  • Ignoring the downspout: a disconnected downspout dumping against the wall undoes a repoint fast.
  • Patching lintel cracks with mortar: the crack returns until the steel is replaced.
  • Redoing the whole house at once when only two walls need it.

Bungalow details worth saving

Bungalow fronts often carry details that are easy to lose in a careless repair: limestone sills and coping on the front bay, soldier courses and patterned brick under the eaves, and art-glass windows set in brick openings. When we work on fronts, we protect the glass, match the patterned brick with salvage, and keep the stone trim instead of replacing it with concrete. The Historic Chicago Bungalow Association has guidance for owners who want to keep original features; it's worth a look before you plan exterior changes.

Quick answers

Is my bungalow brick veneer?Almost never on original Chicago bungalows: walls are solid brick, often with header courses tying the wythes together.
Should I remove an unused bungalow chimney?Sometimes. On a side chimney that no longer vents anything, removal below the roofline can be cheaper than a rebuild.
Do bungalows need permits for masonry repair?In Chicago, usually an Express Permit. See the permit guide.

Bungalow owner in the suburbs? See Berwyn and Park Ridge.

Free estimate

Let us look at the wall before you pay for the whole thing

Three details and we'll call to set a time. We look at the joints, the bricks, the lintels and the chimney, then send a written price.

Rather talk it through? Call us.

We call back within one business day to set up a look at the wall. We use your details only to answer you, and we never sell them.

Call us